Failure of paint to dry to a smooth film, resulting in unsightly brush and roller marks after the paint dries.

• Application of additional paint or rebrushing or re-rolling in areas where the paint has partially dried.
• "Working" (e.g. applying too rapidly or for too long) paint too much during application.
• Use of the wrong type or nap size of roller cover. Use of the wrong type or size of brush.
• Applying too thin of a paint film.
• Painting a hot surface or in direct sunlight.
• Coating a very porous surface.

See Lead Information

• Allow the coating to dry thoroughly, then sand the coating smooth, and repaint.
• Wait until the paint has dried thoroughly before touching up.
• Apply the paint using good painting technique.
• Follow label and data page directions for the appropriate quality, applicator size, and type.
• Follow label and data page directions for the appropriate film build (e.g. thickness of each coating layer).
• Follow label and data page directions for the appropriate environmental conditions.
• Prime or seal porous surfaces.

SUGGESTED FINISH

Reapply the same or an upgrade coating.

See Interior Paints

SUGGESTED FINISH
Reapply the same or an upgrade coating.

See Exterior Paints